1) Description
AAC Block Adhesive is a factory prepared blend of carefully
selected raw materials, Portland cement and graded
aggregates and polymers. Designed for use with water to
produce high strength thixotropic mortar, for laying Aerated
Light weight concrete, Fly ash bricks, cement hollow blocks,
Cellular concrete blocks or smoothing over the block work
surface in layers of upto 12mm thickness, that meet and
exceed the requirements of National and International
Standards.
2) Applications
|
Thin bed mortar for laying blocks: Before placing mortar, ensure the block work to be dry and
surfaces cleaned properly. Place the mixed mortar on the
block work in thin layers of 2 to 3 mm (or as required by
engineers at site) using trowel and place the next layer of
blocks on the mortar. Keep joints between the blocks as
required by the site engineers and fill the joints with the
mixed mortar, using a trowel. Check the plumb of the wall
while laying the blocks to keep the walls perfectly vertical to
the plumb |
|
Smoothing over the block work: Before placing mixed mortar, apply a bonding layer of 1 to
2mm thick AAC Block Adhesive mortar using a trowel
pressing down on the block work. Then apply AAC Block
Adhesive at a thickness of 8 to 10mm and smoothen using a
sponge or rubber / wooden float. |
|
As Adhesive to install tiles: AAC Block Adhesive can be used as a thin-set adhesive to
install tiles/stones on AAC Block/Fly ash brick walls. Use a
suitable notch trowel to achieve desired thickness of
adhesive for installation of tiles /stones on the wall |
3) Advantages
|
High Strength |
|
No curing required after block work is done. |
|
Flexible, shock & impact resistant |
|
Improved adhesion between two blocks |
|
improved bond strength, compressive & tensile strength |
|
Thin jointing with high adhesion to contribute to load bearing capacity of masonry |
|
easy to use |
|
Long working time |
|
Fast & economical |
4) Packaging
Enquiry for AAC BLOCK ADHESIVE
|
